Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge T330 Owner's Manual

Replacing the optional internal USB memory key

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. Locate the USB connector or USB memory key on the system board.
    NOTE: To locate the internal USB connector on the system board, see the System board connectors section.
  2. If installed, remove the USB memory key from the USB connector.
  3. Insert the replacement USB memory key into the USB connector.
    Figure 1. Removing the internal USB memory key
    This figure shows removing the internal USB memory key.
    1. USB memory key
    2. USB port
    Figure 2. Installing the internal USB memory key
    This figure shows installing the internal USB memory key
    1. USB memory key
    2. USB port

Next steps

  1. Follow the procedure listed in the After working inside your system section.
  2. While booting, press F2 to enter System Setup and verify that the USB memory key is detected by the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\