Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge T340 Installation and Service Manual

PDF

Installing the drive backplane

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the front bezel..
  4. Remove the air shroud.
  5. Remove all the drives.

Steps

  1. Align the slots on the backplane with the hooks on the system.
  2. Lower the drive backplane into the system until the release pin locks in place, securing the drive backplane to the system.
  3. Connect the data, signal, and power cables to the backplane.
    Figure 1. Installing the drive backplane
    This image shows how to install the drive backplane

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\