- Notes, cautions, and warnings
- About this document
- Dell EMC PowerEdge T340 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel
- System feet
- Caster wheels – optional
- System cover
- Air shroud
- Intrusion switch
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing the drive carrier
- Removing the drive from the drive carrier
- Installing the drive into the drive carrier
- Removing a 2.5-inch drive from the 3.5-inch drive adapter
- Installing a 2.5-inch drive into the 3.5-inch drive adapter
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch adapter into a 3.5-inch drive carrier
- Optical drive and tape drives
- Drive backplane
- Backplane cable routing
- Four-slot drive blank
- System memory
- Cooling fan
- Optional internal USB memory key
- Expansion cards
- M.2 SSD module
- Optional IDSDM or vFlash module
- Processor and heat sink
- Power supply unit
- Power interposer board
- System battery
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge T340 Installation and Service Manual
System board jumpers and connectors
| Item | Connector | Description |
|---|---|---|
| 1 | FP_USB | Front panel USB connector |
| 2 | PIB_CONN | Power interposer board signal connector |
| 3 | BP_SIG | Backplane signal connector |
| 4 | Slot 1 PCIE_G3_X8 CPU | PCIe card connector 1 |
| 5 | Slot 2 PCIE_G3_X8 CPU | PCIe card connector 2 |
| 6 | Slot 3 PCIE_G3_X1 PCH | PCIe card connector 3 |
| 7 | LEDs (7) | System board diagnostic LED indicators |
| 8 | INT_USB_3.0 | Internal USB |
| 9 | Slot 4 PCIE_G3_X4 PCH | PCIe card connector 4 |
| 10 | T_INTRUSION | Intrusion switch connector |
| 11 | SYS_FAN | Fan |
| 12 | P2 | CPU power connector P2 |
| 13 | A1, A2, A3, A4 | Memory module sockets |
| 14 | P1 | System power P1 |
| 15 | SATA 0-3 | Mini SAS connector |
| 16 | SATA_ODD/SSD | Optical disk drive connector |
| 17 | PWR_EVNT | Power event |
| 18 | J_SATA_2 | SATA connector 2 |
| 19 | CPU | Processor |
| 20 | NVRAM_CLR | NVRAM password Jumper |
| 21 | TPM | Trusted Platform Module connector |
| 22 | PWRD_EN | Reset BIOS password jumper |
| 23 | IDSDM+ vFlash | IDSDM+VFlash connector |
| 24 | Coin cell battery | Coin cell battery |
| 25 | CTRL_PNL | Control panel |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\