- Notes, cautions, and warnings
- About this document
- Dell EMC PowerEdge T340 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel
- System feet
- Caster wheels – optional
- System cover
- Air shroud
- Intrusion switch
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing the drive carrier
- Removing the drive from the drive carrier
- Installing the drive into the drive carrier
- Removing a 2.5-inch drive from the 3.5-inch drive adapter
- Installing a 2.5-inch drive into the 3.5-inch drive adapter
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch adapter into a 3.5-inch drive carrier
- Optical drive and tape drives
- Drive backplane
- Backplane cable routing
- Four-slot drive blank
- System memory
- Cooling fan
- Optional internal USB memory key
- Expansion cards
- M.2 SSD module
- Optional IDSDM or vFlash module
- Processor and heat sink
- Power supply unit
- Power interposer board
- System battery
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge T340 Installation and Service Manual
Removing caster wheels
Prerequisites
- Follow the safety guidelines listed in Safety instructions.
- Place the system on its side on a flat, stable surface.
Steps
- Using the Phillips #2 screwdriver, loosen the captive screw that secures the front wheel unit to the base of the system.
- Push the front wheel unit toward the rear of the system to release the retention hooks, and pull out the front wheel unit.
- Loosen the screw that secures the back wheel unit to the base of the system.
- Push the rear wheel unit toward the front of the system to release
the retention hooks, and pull out the rear wheel unit.
Next steps
- Replace the caster wheels or replace the system feet, as applicable.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\