Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge T340 Installation and Service Manual

PDF

Installing optional IDSDM or vFlash card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud.

Steps

  1. Locate the IDSDM/vFlash connector on the system board. To locate IDSDM/vFlash connector, see System board jumpers and connectors section.
  2. Align the IDSDM/vFlash card with the connector on the system board.
  3. Push the IDSDM/vFlash card until it is firmly seated on the system board.
    Figure 1. Installing optional IDSDM or vFlash card
    This image shows how to install optional IDSDM or vFlash card.

Next steps

  1. Install the MicroSD cards.
    NOTE Reinstall the MicroSD cards into the same slots that are based on the labels you had marked on the cards during removal.
  2. Install the air shroud.
  3. Follow the procedure that is listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\