Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Technologies PowerEdge T640 Installation and Service Manual

PDF

Installing the air shroud

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. If applicable, route the cables inside the system along the chassis wall and secure the cables by using the cable-securing bracket.

Steps

  1. Align the tabs on the air shroud with the securing slots on the chassis.
    1. Guide on the air shroud with the guide pin on the system board.
    2. Align the intrusion switch with the intrusion switch connector on the system board.
  2. Lower the air shroud into the chassis until it is firmly seated.
    When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
  3. NOTE: The procedure to install the cooling fan into the air shroud is similar to installing a cooling fan.
    If removed, install the fans into the air shroud.
    Figure 1. Installing the air shroud
    This figure shows installing the air shroud.

Next steps

  1. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\