The PowerEdge systems support DDR4 Registered DIMMs (RDIMMs), Load Reduced DIMMs (LRDIMMs), and Non-Volatile DIMMs (NVDIMM-Ns). System memory holds the instructions that are executed by the processor.
Your system contains 24 memory sockets split into two sets of 12 sockets, one set per processor. Each 12-socket set is organized into six channels. Six memory channels are allocated to each processor. In each channel, the release tabs of the first socket are marked white, and the second socket black.
Memory channels are organized as follows:
Table 1. Memory channelsThis tables describes memory channels and how the channels are organized.
Processor
Channel 0
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Processor 1
Slots A1 and A7
Slots A2 and A8
Slots A3 and A9
Slots A4 and A10
Slots A5 and A11
Slots A6 and A12
Processor 2
Slots B1 and B7
Slots B2 and B8
Slots B3 and B9
Slots B4 and B10
Slots B5 and B11
Slots B6 and B12
The following table shows the memory populations and operating frequencies for the supported configurations:
Table 2. Memory populationThis table describes the memory population and the operating frequencies.
DIMM Type
DIMMs Populated/Channel
Voltage
Operating Frequency (in MT/s)
Maximum DIMM Rank/Channel
RDIMM
1
1.2 V
2933, 2666, 2400, 2133
Dual rank or single rank
2
2933, 2666, 2400, 2133
Dual rank or single rank
LRDIMM
1
1.2 V
2933, 2666, 2400, 2133
Quad rank or Octo rank
2
2666, 2400, 2133
Quad rank or Octo rank
NVDIMM-N
1
1.2 V
2933, 2666, 2400, 2133
Single rank
NVDIMM population rules
Maximum of one NVDIMM per channel.
Maximum of six NVDIMMs per processor
Maximum capacity per NVDIMM is 16GB
NVDIMMs are not supported on the following configurations:
32 x 2.5-inch SAS/SATA/SSD drive configuration
16 x 2.5-inch SAS/SATA/SSD drives with 8 x NVME drive configuration
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\