ME4 Series Storage
Systems provide many ways to isolate faults. This section presents
the basic methodology that is used to locate faults within a storage system,
and to identify the pertinent CRUs affected.
As noted in Using guided setup, use the PowerVault Manager to configure
and provision the system upon completing the hardware installation.
Configure and enable event notification to be notified when a problem occurs that is at or above
the configured severity. See the Dell PowerVault ME4 Series Storage System Administrator’s Guide for more information.
When you receive an event notification, follow the recommended actions in
the notification message to resolve the problem.
If required, isolate
the fault to a data path component or configuration as described in Isolate the fault.
Cabling systems to enable use of the replication feature—to
replicate volumes—is another important fault isolation consideration
pertaining to initial system installation. See Host ports and replication and Isolating replication faults for more information about troubleshooting during initial setup.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\