Attach a XenServer host with network adapters to the storage system
Perform the following steps to attach a XenServer host with network adapters to the storage system:
Ensure that all network adapters have the latest supported firmware and drivers as described on
Dell.com/support.
NOTE:The
Dell PowerVault ME4 Series storage system supports only software iSCSI adapters.
Use the iSCSI cabling diagrams to cable the host servers either by using switches or attaching them directly to the storage system using one-to-one mode. Record the two different IP address ranges for each storage system controller. For example: 172.2.15.x, 172.3.20.x.
If the host servers are connected to the storage system by iSCSI switches, configure the switches to use two different IP address ranges/subnets.
NOTE:Configuring the switches with two different IP address ranges/subnets enables high availability.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\