- Notes, cautions, and warnings
- Introduction
- Supported data protocols
- ME4 Series storage system rules
- Default IPv4 Settings for management ports
- Default IPv4 settings for iSCSI ports
- Supported RAID controller firmware
- Supported iSCSI software initiators
- Supported protocol offload (TOE/iSCSI) adapters
- Supported Fibre Channel and iSCSI SFP+ transceivers
- Supported SAS and Twinax direct-attach cables
- Supported hard drives
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Operating systems with ALUA support
- Supported device mapper software
- Supported SAS host bus adapters
- Supported Fibre Channel host bus adapters
- Supported Fibre Channel and iSCSI direct-attach configuration operating systems
- Dell EMC Storage Support Policy
Dell PowerVault ME4 Series Storage System Support Matrix
Supported Fibre Channel and iSCSI SFP+ transceivers
This following table lists the Fibre Channel and iSCSI transceivers that have been tested for use with ME4 Series storage systems:
| Description | Manufacturer Part Number | Dell Part Number |
|---|---|---|
| 16 Gb SFP+ short-wavelength transceiver (FC) | FTLF8529P3BCVA | TDTCP |
| 16 Gb SFP+ short-wavelength transceiver (FC) | FTLF8529P4BCV-D2 | NKX77 |
| 16 Gb SFP+ short-wavelength transceiver (FC) | AFBR-57F5MZ-FT2 | NKX77 |
| 10GBASE-SR 850 nm SFP+ short-range transceiver (iSCSI) | FTLX8574D3BCL-DL | C5RNH |
| 10GBASE-SR 850 nm SFP+ short-range transceiver (iSCSI) | AFBR-709SMZ-FT2 | C5RNH |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\