- Notes, cautions, and warnings
- Introduction
- Supported data protocols
- ME4 Series storage system rules
- Default IPv4 Settings for management ports
- Default IPv4 settings for iSCSI ports
- Supported RAID controller firmware
- Supported iSCSI software initiators
- Supported protocol offload (TOE/iSCSI) adapters
- Supported Fibre Channel and iSCSI SFP+ transceivers
- Supported SAS and Twinax direct-attach cables
- Supported hard drives
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Operating systems with ALUA support
- Supported device mapper software
- Supported SAS host bus adapters
- Supported Fibre Channel host bus adapters
- Supported Fibre Channel and iSCSI direct-attach configuration operating systems
- Dell EMC Storage Support Policy
Dell PowerVault ME4 Series Storage System Support Matrix
Supported RAID controller firmware
NOTE
- Dell recommends gathering support information before performing any firmware update.
- Only drivers and firmware released by Dell are supported. For the latest driver and firmware releases, see the Drivers & Downloads section at https://www.dell.com/support.
| Software | Version |
|---|---|
| RAID controller firmware | GT280R011-01 |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\