Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Precision 7920 Rack Owner's Manual

PDF

Teradici Tera2220 Host Cards Installation

This section describes the installation of Teradici host cards into the system. The host cards should have the low-profile PCI card brackets installed to fit into riser 1 on the Dell Precision Rack 7910.

Host card

To install the host card, complete the following steps:
  1. Remove the low-profile module that contains riser 1 from the chassis.
  2. Open the PCI card support bracket on the back of the module.

    Installing Host card

  3. Open the retention clip for the low-profile PCI cards.

    Installing Host card

  4. Install the three Teradici host cards into their respective PCIe slots.
  5. Make sure the cards are sitting flush, and press the retaining bracket and the support bracket back into place.

    Installing Host card

  6. Install the host card's power button cables into the rear of the Teradici host cards. The image below shows the rear of the low-profile module and host cards

    Installing Host card

  7. Install the low-profile module back into the chassis in slot 1. Make sure the power button cables are not pinched between the module and the chassis case.

    Installing Host card

  8. Make sure the module is aligned correctly and press down firmly to seat it in the slot.

    Installing Host card

  9. Remove the CPU air baffle from the chassis.
  10. Route the power button cable from the closest Teradici host card as shown below, and insert the 2-pin female receptacle into P34 on the motherboard.

    Installing Host card

  11. Daisy-chain the remaining connectors by connecting the 2-pin female connector on the additional cables to the male connector on the previous cable.
  12. Reinstall the air baffle over the CPU heat sinks

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\