Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Precision 7920 Rack Owner's Manual

PDF

Installing expansion card riser 3

Steps

  1. Align the following:
    1. Tab on the riser with the slot on the system and guide rails on the riser with the standoffs on the side of the system.
    2. Lower the riser into the system until the riser edge connector engages with the connector on the system board.
      The riser card edge engages with the riser guide on the system.
  2. Using Phillips #2 screwdriver, tighten the screw to secure the riser to the system.

Next steps

  1. If removed, install expansion cards into the riser and connect any cable disconnected.
  2. If applicable, install the air shroud.
    NOTE:If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
  3. Install any device drivers required for the card as described in the documentation for the card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\