Install
Red Hat Enterprise Linux 9 on iSCSI storage
CAUTION Ensure that you back up all the data from the system before installing or upgrading the operating system.
RHEL 9 based systems can connect to an iSCSI storage array either through an iSCSI software stack, an iSCSI Host Bus Adapter (HBA), or an iSCSI offload hardware.
Configure the network interface controllers to access the iSCSI storage.
Select the installation destination in the
Installation Destination window.
Click
Add a disk in the
Specialized & Network Disks section.
In the
Storage Device Selection window, click the
Other SAN Devices tab.
Select the SAN device, and then click
Done to continue with the installation.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\