Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge Systems Red Hat Enterprise Linux 9 Installation Guide

Install Red Hat Enterprise Linux 9 using hardware iSCSI initiator

About this task

CAUTION Ensure that you back up all the data from the system before installing or upgrading the operating system.


  1. Configure the network interface controllers to access the iSCSI storage.
  2. Select the installation destination in the Installation Destination window.
  3. Click Add a disk in the Specialized & Network Disks section.
  4. In the Storage Device Selection window, click the Other SAN Devices tab.
  5. Select the SAN device, and then click Done to continue with the installation.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\