Description
On
Storage Center 5.0 and later, shows server port/HBA information for each attached
server known to the
Storage Center. Output depends on the filter options specified.
You can run this command on
Storage Centers that have the following:
- One or more preconfigured servers
- One or more servers that have been discovered and
configured, including a mix of operational and connection status values
- One or more discovered ports that have not yet been
configured (assigned to a server), including a mix of operational
and connection status values
Options
–connectstatus
string
Specifies the status of the transport
connection between the server port/HBA and the
Storage Center by which to filter the
display. Valid values are:
-
Connected: indicates that all
primary paths are up between the HBA and the
Storage Center.
-
Disconnected: indicates that
no primary paths are up between the HBA and the
Storage Center.
-
Partially Connected: (requires
single quotes) indicates that at least one primary path is up and
at least one primary path is down between the HBA and the
Storage Center.
–csv
filename
Specifies a csv file in which to save
output.
–h
Shows
help for command options.
–hbatype
string
Specifies
the transport type of the server port/HBA by which to filter the display.
Valid values are:
–ipaddress
string
Specifies the IP address for the iSCSI
server port/HBA by which to filter the display (iSCSI only).
–iscsi_name
string
Specifies the unique iSCSI transport name
for the server port/HBA by which to filter the display (iSCSI only).
–portinfo
string
Specifies additional, protocol- and device-specific
information by which to filter the display.
–server
string
Specifies the index of the server host for the port/HBA
by which to filter the display.
–servername
string
Specifies the
name of the server host for the port/HBA by which to filter the display.
–status
string
Specifies the operational status of the
server port/HBA by which to filter the display. Valid values are:
–txt
filename
Specifies a text file in which to save
output.
–wwn
string
Specifies the remote port Initiator name
or the World Wide Name (WWN) for the server port/HBA by which to filter
the display.
–xml
filename
Specifies an xml file in which to save
output.