Configure the local host from Initial Setup
to access block-level storage on the Storage Center.
Prerequisites
The Storage Manager Client must be running on a system with a 64-bit operating
system.
You must be logged into the Storage Manager Client using a Storage Manager user with the Administrator privilege.
On a Storage Center with Fibre Channel I/O ports,
configure Fibre Channel zoning before starting this procedure.
Steps
On the Configuration Complete page of the Discover and Configure wizard,
click Set up block level storage for this host.
The Set up localhost for wizard opens.
If the Storage Center has iSCSI ports and the host is not connected to any interface,
the Log into via iSCSI page opens. Select
the target fault domains, and then click Log In.
In all other cases, the Verify localhost
Information page opens. Proceed to the next step.
On the Verify localhost Information page, verify that the information is correct. Then click Create Server.
The server definition is created on the Storage Center for the connected and
partially connected initiators.
The Host Setup Successful page displays the best practices that were set by the wizard and
best practices that were not set. Make a note of any best practices
that were not set. It is recommended that these updates be applied
manually before starting I/O to the Storage Center.
(Optional) Select Create a Volume
for this host to create a volume after finishing host
setup.
Click Finish.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\