The following
conditions must be fulfilled before you enable FRM:
ESXi 5.5 must be deployed on one the following Dell PowerEdge
systems:
FC630
M630
M620
R920
R820
R7910
R730
R730XD
R720
R720XD
R630
R620
R530
R430
T630
T620
T430
The BIOS version on your system must be 1.0.4 or later for Dell’s
13th generation and 2.0.19 or later for Dell’s 12th generation of
PowerEdge systems.
The memory modules must be populated on the memory channels to
support Mirror Mode. For more information,
see your system Owner’s Manual at dell.com/poweredgemanuals.
You need vSphere Enterprise or Enterprise Plus licensing to enable
the VMware Reliable Memory technology.
To enable
FRM on your system, complete the following procedure:
Turn on your system.
The Dell logo is displayed.
Press F2 to open the System Setup page.
Use the up- and down-arrow keys to select the System BIOS option, and then select Memory
Settings .
Select Dell Fault Resilient Mode for Memory Operating Mode
CAUTION: Dell recommends that you do not modify other settings
unless you are familiar with the settings. Modifying settings could
cause your system to fail to boot or function properly.
Press Enter, and follow the on-screen procedure to save
these changes
Restart your system.
NOTE: No further
configuration changes are required for ESXi to make use of the reliable
memory region.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\