Remove the four M2.0 x 2 screws that secure the display panel to the display assembly [1] and lift to turn over the display panel to access the eDP cable [2].
Remove the adhesive tape [1].
Lift the latch and disconnect the display cable from the connector on the display panel [2].
Lift the display panel [3].
The component you are left with is the display panel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\