Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Vostro 15 3510 Service Manual

PDF

Installing the display assembly

CAUTION: The maximum operating angle for the display-panel hinge is 135 degrees.
NOTE: Ensure that the hinges are opened to the maximum before replacing the display assembly on the palmrest and keyboard assembly.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

image of display assembly installation

image 2 of display assembly installation

image 3 of display assembly installation

Steps

  1. Align and place the system under the hinges on the display assembly.
  2. Fold the hinges back and install the four (M2.5x5) screws to secure the display assembly.
  3. Re-route the speaker and WLAN antenna cables through the routing channels on the palmrest.
  4. Reconnect the display cable to the connector on the system board.

Next steps

  1. Install the WLAN card.
  2. Install the base cover.
  3. Exit service mode.
  4. Install the SD card.
  5. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\