Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Vostro 15 3510 Service Manual

PDF

Installation display panel

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the display panel and provides a visual representation of the installation procedure.

image of installing the display panel

image of installing the display panel

image of installing the display panel

Steps

  1. Place the display panel on a flat and clean surface .
  2. Connect the display cable to the connector at the back of the display panel and close the latch to secure the cable .
  3. Adhere the tape that secures the display cable to the back of the display panel .
  4. Turn the display panel over and place it on the display back-cover.
  5. Lift the bottom side of the display panel and slide the top side into the slots at the top of the display back-cover.
  6. Gently push down on the edges of the display panel until it clicks into the tabs on the display back-cover.

Next steps

  1. Install the display bezel.
  2. Install the hinge caps.
  3. Install the display assembly.
  4. Install the WLAN card.
  5. Install the base cover.
  6. Exit service mode.
  7. Install the SD card.
  8. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\