- Notes, cautions, and warnings
- Welcome to Dell Wyse 5070 extended thin client
- Chassis overview
- Major components of your thin client
- Supported system peripherals for Wyse 5070 thin client
- Setting up the thin client
- Before working on your thin client
- After working on your thin client
- Removing and installing components
- Safety instructions
- Before working on your thin client
- Safety precautions
- After working on your thin client
- Recommended tools
- Screw size list
- Chassis cover
- PCIe module
- Coin-cell battery
- Solid-state drive
- Expansion module
- Wireless card
- CAC reader
- Memory
- Speaker and power button
- Serial and parallel port
- Heat sink
- System board
- Technical specifications
- Wyse 5070 thin client configuration on ThinOS
- Wyse 5070 thin client on ThinLinux
- Wyse 5070 thin client on Windows 10 IoT Enterprise
- BIOS overview
- Accessing thin client BIOS settings
- System Setup overview
- Boot Sequence
- Navigation keys
- General screen options
- System Configuration screen options
- Video screen option
- Security screen options
- Secure Boot screen options
- Performance screen options
- Power management screen options
- POST behavior screen options
- Wireless screen option
- Virtualization support screen options
- Maintenance screen options
- System Logs screen option
- Troubleshooting your system
Dell Wyse 5070 Extended Thin Client User Guide
Accessing thin client BIOS settings
This section
describes about the Wyse 5070 thin client UEFI BIOS settings. While
starting a thin client, a Dell logo is displayed for a short period.
- During start-up, press the F2 key.
and enter the default password Fireport.
The BIOS settings dialog box is displayed.
- Use the System Setup settings to change the BIOS settings.
NOTE There is an option to restore BIOS defaults, Factory Defaults, and Custom user settings for Users in the BIOS menu. BIOS default setting restores the values that was part of the BIOS file. Restoring Factory default restores the BIOS setting to the values that was configured in factory before shipping the client.
To access
the boot menu during start-up, press the F12 key. Use the Boot Selection menu to select or view the boot sequence
order as follows:
- Boot from UEFI: Hard Drive, Partition 4
- Onboard NIC (IPV4)
- Onboard NIC (IPV6)
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\