- Notes, cautions, and warnings
- Welcome to Dell Wyse 5070 extended thin client
- Chassis overview
- Major components of your thin client
- Supported system peripherals for Wyse 5070 thin client
- Setting up the thin client
- Before working on your thin client
- After working on your thin client
- Removing and installing components
- Safety instructions
- Before working on your thin client
- Safety precautions
- After working on your thin client
- Recommended tools
- Screw size list
- Chassis cover
- PCIe module
- Coin-cell battery
- Solid-state drive
- Expansion module
- Wireless card
- CAC reader
- Memory
- Speaker and power button
- Serial and parallel port
- Heat sink
- System board
- Technical specifications
- Wyse 5070 thin client configuration on ThinOS
- Wyse 5070 thin client on ThinLinux
- Wyse 5070 thin client on Windows 10 IoT Enterprise
- BIOS overview
- Accessing thin client BIOS settings
- System Setup overview
- Boot Sequence
- Navigation keys
- General screen options
- System Configuration screen options
- Video screen option
- Security screen options
- Secure Boot screen options
- Performance screen options
- Power management screen options
- POST behavior screen options
- Wireless screen option
- Virtualization support screen options
- Maintenance screen options
- System Logs screen option
- Troubleshooting your system
Dell Wyse 5070 Extended Thin Client User Guide
Configuring display on Dell Wyse ThinLinux
By default,
the Customize your display screen is available in both User
mode and Admin mode. Any changes to display preferences made through
this screen is saved and available for the built-in thinuser. In a Dual-monitor configuration, if both monitors are connected, then
by default, the monitors are in extended mode. The primary monitor is on the left (monitor 1) and the secondary monitor is on
the right (monitor 2). The resolutions of the monitors are auto detected
by the system by analyzing the monitor’s capabilities.
- Click the Display tab.The Customize Your Display page is displayed.
Figure 1. Display Settings 
- Select the preferred Resolution from the drop-down list.
- Select the Rotation type from the drop-down
list.
- Normal
- Right
- Left
- Upside-down
- Click the ON/OFF button to switch between dual display and mirror mode in a dual monitor configuration.
- Click the ON/OFF button to enable the Set as primary option. This option allows you to set the selected monitor as primary.
- Click the ON/OFF button to enable the Monitor On/Off option. This option allows you to switch off and switch on the preferred monitor in a dual monitor configuration.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\