- Notes, cautions, and warnings
- Welcome to Dell Wyse 5070 extended thin client
- Chassis overview
- Major components of your thin client
- Supported system peripherals for Wyse 5070 thin client
- Setting up the thin client
- Before working on your thin client
- After working on your thin client
- Removing and installing components
- Safety instructions
- Before working on your thin client
- Safety precautions
- After working on your thin client
- Recommended tools
- Screw size list
- Chassis cover
- PCIe module
- Coin-cell battery
- Solid-state drive
- Expansion module
- Wireless card
- CAC reader
- Memory
- Speaker and power button
- Serial and parallel port
- Heat sink
- System board
- Technical specifications
- Wyse 5070 thin client configuration on ThinOS
- Wyse 5070 thin client on ThinLinux
- Wyse 5070 thin client on Windows 10 IoT Enterprise
- BIOS overview
- Accessing thin client BIOS settings
- System Setup overview
- Boot Sequence
- Navigation keys
- General screen options
- System Configuration screen options
- Video screen option
- Security screen options
- Secure Boot screen options
- Performance screen options
- Power management screen options
- POST behavior screen options
- Wireless screen option
- Virtualization support screen options
- Maintenance screen options
- System Logs screen option
- Troubleshooting your system
Dell Wyse 5070 Extended Thin Client User Guide
Procedure
- Follow the procedure in Before working inside your thin client.
- Disconnect the parallel port cable from the
system board.
Figure 1. Disconnect the parallel port cable 
- Remove the four screws that secure the serial
and parallel port to the chassis.
Figure 2. Remove the four screws 
- Pull and lift the serial and parallel port
away from the chassis.
Figure 3. Pull and lift the serial and parallel port 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\