This section is applicable to Wyse 5070 thin client. ThinOS supports multiple-monitor display to run virtual machines on each monitor.
Prerequisite: Update the VMware Blast package to
the latest version. For more information, see the latest Dell Wyse ThinOS Release Notes.
User scenario:
Connect multiple monitors to the ThinOS device.
In the Display Setup dialog box, disable Mirror
Mode, and configure the display layout.
Launch a full screen VMware Horizon Blast session.
Display numbers—A virtual machine needs sufficient video memory to support multiple monitors. You
can use up to four monitors with sufficient RAM.
Table 1. Display Layout matrixDisplay matrix
Resolution
1920 x 1080
2560 x 1440
No. of displays
Two
Three
Four
Five
Six
Two
Three
Four
Five
Six
Horizontal
Yes
Yes
Yes
NA
NA
Yes
Yes
Yes
NA
NA
Vertical
Yes
Yes
Yes
NA
NA
Yes
Yes
Yes
NA
NA
Grid
Yes
Yes
Yes
NA
NA
Yes
Yes
Yes
NA
NA
4K display—ThinOS supports four displays with 4K resolution in a Horizon blast session. Due to low performance, Dell recommends that you do not use four displays with 4K resolution.
Table 2. 4K display support4K display support
Hardware version
Windows version
Number of 4K displays supported
10 (ESXi 5.5.x compatible)
7, 8, 8.x, and 10
1
11 (ESXi 6.0 compatible)
7—3D rendering feature and Windows Aero are disabled.
3
11
7—3D rendering feature is enabled.
1
11
8, 8.x, and 10
1
3D rendering—You can configure 3D graphics rendering for connected desktops. To use the 3D rendering feature, use up to two monitors with
a resolution of up to 1920 x 1200. For a resolution of 4K (3840 x
2160), only one monitor is supported.
Blast H.264—The following table describes the performance of H.264 decoder in VMware Horizon sessions that use the VMware Blast display protocol:
Table 3. Blast H.264 decodingBlast H.264 decoding
Screen resolution within VMware Horizon Blast session
Blast H.264 decoding in VMware Horizon Blast session
Summary
Session display width is less than or equal to 1920 pixels.
Blast H.264 decoding is always enabled.
Horizon client uses Blast H.264 decoding even if the H.264 decoder setting is disabled using GUI or INI options.
Session display width is greater than 1920 pixels.
Blast H.264 decoding is disabled by default. You can enable Blast H.264 decoding either on the ThinOS GUI or by deploying the INI parameter.
By default, Horizon client does not use Blast H.264 decoding. If the Blast H.264 decoder setting is enabled on ThinOS, then the Horizon client uses H.264 decoding. Enabling H.264 may downgrade the session performance.
For more information about the monitors and screen resolution, see the Monitors and Screen resolution section in the Horizon 7 Architecture Planning article at docs.vmware.com. However, Dell does not recommend that you use four displays with 4K resolution due to low performance.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\