Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Profitez de récompenses et de remises réservées aux membres
  • Créez et accédez à une liste de vos produits

Alienware m15 R3 Service Manual

Installing the speakers

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the speakers and provides a visual representation of the installation procedure.

Installing the speakers

Steps

  1. Using the alignment posts, place the left speaker on the palm-rest assembly.
    NOTE Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
  2. Route the speaker cable through the routing guides on the palm-rest assembly.
  3. Using the alignment posts, place the right speaker on the palm-rest assembly.
    NOTE Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
  4. Connect the speaker cable to the right I/O-board.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\