Pular para o conteúdo principal
Sair

Boas-vindas à Dell

Minha conta
  • Faça pedidos de forma rápida e simples
  • Visualize os pedidos e acompanhe o status de envio
  • Crie e acesse uma lista dos seus produtos
  • Gerencie seus sites, produtos e contatos de nível de produto da Dell EMC usando o Company Administration.
Login Crie sua conta Premier login Inscrição no programa de parceria
Fale Conosco

Seus carrinhos no Dell.com

Dell PowerEdge R730xd Owner's Manual

PDF

Installing the I/O panel

Prerequisites

  1. Follow the safety guidelines listed in safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the T15 Torx screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Fold the PPID label around the cable.
  2. Push the cable until the cable passes completely through the channel.
    CAUTION: To prevent damage to the I/O cable, you must release the locking tab before removing or installing the I/O cable from the connector on the hard drive backplane.
  3. If locked, rotate the locking tab on the I/O cable connector clockwise 90 degrees to release the lock.
  4. Connect the I/O panel cable to the connector on the hard drive backplane.
  5. Rotate the locking tab on the I/O cable connector counter clockwise 90 degrees to secure the lock.
  6. Tighten the screws to secure the control panel to the chassis.
    NOTE: You must route the cable properly to prevent it from being pinched or crimped.
    Figure 1. Installing the I/O panel
    This figure shows installing the I/O panel.
    1. I/O panel cable
    2. hard drive backplane
    3. screw (3)
    4. I/O panel
    5. chassis

Next steps

Follow the procedure listed in the After working inside your system section.

Classifique este conteúdo

Preciso
Úteis
Fácil de entender
Este artigo foi útil?
0/3000 characters
  Forneça as classificações (de 1 a 5 estrelas).
  Forneça as classificações (de 1 a 5 estrelas).
  Forneça as classificações (de 1 a 5 estrelas).
  Selecione se o artigo foi útil ou não.
  Os comentários não podem conter estes caracteres especiais: <>()\