Preskočiť na hlavný obsah
Odhlásiť sa

Vitajte v spoločnosti Dell!

Moje konto
  • Zadávajte objednávky rýchlo a jednoducho
  • Pozrite si svoje objednávky a sledujte priebeh doručenia
  • Vytvorte si zoznam svojich produktov a majte ho vždy poruke
  • Spravujte svoje lokality Dell EMC, produkty a kontaktné informácie na úrovni produktov pomocou Správy informácií o spoločnosti.
Prihlásiť sa Vytvoriť konto Prihlásenie na stránky Premier Prihlásenie do partnerského programu
Kontaktujte nás

Latitude 5540 Owner's Manual

PDF

Safety precautions

The safety precautions chapter details the primary steps to be taken before performing any disassembly instructions.

Standby power

Observe the following safety precautions before you perform any installation or break/fix procedures involving disassembly or reassembly:
  • Turn off the system and all attached peripherals.
  • Disconnect the system and all attached peripherals from AC power.
  • Disconnect all network cables, telephone, and telecommunications lines from the system.
  • Use an ESD field service kit when working inside any to avoid electrostatic discharge (ESD) damage.
  • After removing any system component, carefully place the removed component on an anti-static mat.
  • Wear shoes with non-conductive rubber soles to reduce the chance of getting electrocuted.

Dell products with standby power must be unplugged before you open the case. Systems that incorporate standby power are essentially powered while turned off. The internal power enables the system to be remotely turned on (wake on LAN) and suspended into a sleep mode and has other advanced power management features.

Unplugging, pressing, and holding the power button for 15 seconds should discharge residual power in the system board.

Bonding

Bonding is a method for connecting two or more grounding conductors to the same electrical potential. This is done through the use of a field service electrostatic discharge (ESD) kit. When connecting a bonding wire, ensure that it is connected to bare metal and never to a painted or non-metal surface. The wrist strap should be secure and in full contact with your skin, and ensure that you remove all jewelry such as watches, bracelets, or rings prior to bonding yourself and the equipment.

Ohodnotiť tento obsah

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
0/3000 characters
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, či vám článok pomohol alebo nie.
  Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\