Gå vidare till huvudinnehållet
Logga ut

Välkommen till Dell

Mitt konto
  • Lägg beställningar snabbt och enkelt
  • Visa beställningar och kontrollera leveransstatus
  • Skapa och kom åt en lista över dina produkter
  • Hantera dina webbplatser, produkter och kontakter på produktnivå från Dell EMC med hjälp av företagsadministration.
Logga in Skapa ett konto Premier-inloggning Partner Program-inloggning
Kontakta oss

Dina kundvagnar på Dell.com

Dell PowerEdge T630 Owner's Manual

PDF

Troubleshooting a drive or SSD

Prerequisites

CAUTION: This troubleshooting procedure can erase data stored on the drive. Before you proceed, back up all files on the drive.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Run the appropriate diagnostic test. See the Using system diagnostics section.

    Depending on the results of the diagnostics test, proceed as required through the following steps.

  2. If your system has a RAID controller and your drives are configured in a RAID array, perform the following steps:
    1. Restart the system and press F10 during system startup to run the Dell Lifecycle Controller, and then run the Hardware Configuration wizard to check the RAID configuration.
      See the Dell Lifecycle Controller documentation or online help for information about RAID configuration.
    2. Ensure that the drives are configured correctly for the RAID array.
    3. Take the drive offline and reseat the drive.
    4. Exit the configuration utility and allow the system to boot to the operating system.
  3. Ensure that the needed device drivers for your controller card are installed and are configured correctly. For more information, see the operating system documentation.
  4. Restart the system and enter the System Setup.
  5. Verify that the controller is enabled and the drives are displayed in the System Setup.

Next steps

If the problem persists, see the Getting help section.

Betygsätt det här innehållet

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
0/3000 characters
  Ange betyg (1–5 stjärnor).
  Ange betyg (1–5 stjärnor).
  Ange betyg (1–5 stjärnor).
  Ange om artikeln var användbar eller inte.
  Kommentarer får inte innehålla följande specialtecken: <>()\