Gå vidare till huvudinnehållet
Logga ut

Välkommen till Dell

Mitt konto
  • Lägg beställningar snabbt och enkelt
  • Visa beställningar och kontrollera leveransstatus
  • Skapa och kom åt en lista över dina produkter
  • Hantera dina webbplatser, produkter och kontakter på produktnivå från Dell EMC med hjälp av företagsadministration.
Logga in Skapa ett konto Premier-inloggning Partner Program-inloggning
Kontakta oss

Dina kundvagnar på Dell.com

Dell PowerEdge T630 Owner's Manual

PDF

Troubleshooting expansion cards

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: When troubleshooting an expansion card, you also have to see the documentation for your operating system and the expansion card.
NOTE: Riser slots are not hot-pluggable.

Steps

  1. Run the appropriate diagnostic test. See the Using system diagnostics section.
  2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
  3. Remove the system cover.
  4. Ensure that each expansion card is firmly seated in its connector.
  5. Install the system cover.
  6. Turn on the system and attached peripherals.
  7. If the problem is not resolved, turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
  8. Remove the system cover.
  9. Remove all expansion cards installed in the system.
  10. Install the system cover.
  11. Run the appropriate diagnostic test. See the Using system diagnostics section.

    If the tests fail, see the Getting help section.

  12. For each expansion card you removed in step 8, perform the following steps:
    1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
    2. Remove the system cover.
    3. Reinstall one of the expansion cards.
    4. Install the system cover.
    5. Run the appropriate diagnostic test. See the Using system diagnostics section.

Next steps

If the problem persists, see the Getting help section.

Betygsätt det här innehållet

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
0/3000 characters
  Ange betyg (1–5 stjärnor).
  Ange betyg (1–5 stjärnor).
  Ange betyg (1–5 stjärnor).
  Ange om artikeln var användbar eller inte.
  Kommentarer får inte innehålla följande specialtecken: <>()\