Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Alienware m17 R2 Service Manual

PDF

Installing the power-button assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the power-button assembly and provides a visual representation of the installation procedure.

Image: Installing the power-button assembly

Steps

  1. Place the power-button assembly and its cable in the slot on the palm-rest assembly.
  2. Place the power-button bracket on the power-button assembly.
  3. Connect the power-button assembly cable to the left I/O-board and close the connector latch.
  4. Replace the three (M2x1.9) screws that secure the power-button bracket to the palm-rest assembly.
  5. Adhere the power-button assembly cable on the palm-rest assembly.

Next steps

  1. Install the system board.
  2. Install the battery.
  3. Install the rear I/O-cover.
  4. Install the 2230 solid-state drive. (if applicable)
  5. Install the 2280 solid-state drive. (if applicable)
  6. Install the base cover.
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\