- Notes, cautions, and warnings
- About this document
- PowerEdge MX740c sled overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX740c sled
- System cover
- Air shroud
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC card
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge MX740c Installation and Service Manual
Mezzanine card
Your system supports two mezzanine cards:
- PCIe mezzanine card slot A supports fabric A. This card must match the fabric type of I/O modules installed in I/O module bays A1.
- PCIe mezzanine card slot B supports fabric B. This card must match the fabric type of I/O modules installed in I/O module bays B1.
NOTE The Mezzanine B1 card requires processor 2 to be installed.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\