The PowerEdge
I/O Aggregator is a layer 2 switch blade with two fixed 40 GbE ports
on the base module and provides support for two optional plug-in modules.
The Aggregator runs the Dell Force10 Operating System (FTOS) and autoconfigures
as an unmanaged switch with bridging and multiplexing features.
This module provides:
Thirty-two 1/10-Gigabit Ethernet internal ports-each port can
operate in either 1 GbE or 10 GbE mode.
An internal Ethernet interface for switch management.
Two fixed 40 GbE ports on the base module. These ports operate
in 4 x 10 GbE mode with breakout cables and support up to eight 10
GbE uplink ports. The 40 GbE ports can be configured as stacking links.
FlexIO plug-in modules in two expansion slots:
Four-port 10 GbE module using SFP+ optics or direct-attach cables
(1 m, 3 m, or 5 m DAC)
Four-port 10GBASE-T module using RJ-45 connector (copper) cables
Two-port 40 GbE QSFP+ module for 10 GbE SFP+ connections using
4 x 10 GbE breakout cables.
For additional information about the PowerEdge M I/O Aggregator
switch module, see the documentation that shipped with the module.
Figure 1. Dell PowerEdge
M I/O Aggregator Switch
expansion slot 1
expansion slot 0
USB storage port
activity and link LEDs
USB console port
40 GbE QSFP+ ports
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
