- Notes, cautions, and warnings
- About your system
- Initial system configuration
- Before You Begin
- Initial Setup Sequence
- Initial CMC Network Configuration
- Logging In To The CMC Using The Web-Based Interface
- Adding And Managing CMC Users
- Configuring iDRAC Networking Using The Web-Based Interface
- Setting The First Boot Device For Servers
- Configuring And Managing Power
- Installing Or Updating The CMC Firmware
- Configuring The Optional iKVM Switch Module
- FlexAddress
- FlexAddress Plus
- Configuring The I/O Modules
- Network Information
- I/O Connectivity
- Port Auto-Disablement in Quad-Port Network Daughter Card (Dell PowerEdge M710HD Only)
- Mezzanine Cards
- I/O Module Port Mapping—Full-Height Blades
- I/O Module Port Mapping─Half-Height Blades
- I/O Modules—Switches
- Configuring A Switch Module Network Ethernet Port Using The Web-Based Interface
- Brocade M6505 16 Gbps FC SAN I/O Module
- Cisco Nexus B22 Fabric Extender Module
- Dell PowerEdge M I/O Aggregator Switch
- Dell Force10 MXL 10/40 GbE Switch
- Mellanox M4001F/M4001Q/M4001T Infiniband Switch I/O Module
- Dell PowerConnect KR 8024-k Switch
- Dell PowerConnect M8428-k 10 Gb Converged Network Switch
- Mellanox M2401G DDR Infiniband Switch I/O Module
- Mellanox M3601Q QDR Infiniband Switch I/O Module
- Cisco Catalyst Ethernet Switch I/O Modules
- Dell PowerConnect M6348 1 Gb Ethernet Switch I/O Module
- Dell PowerConnect M6220 Ethernet Switch I/O Module
- Dell PowerConnect M8024 10 Gb Ethernet Switch I/O Module
- Dell 8/4 Gbps FC SAN Module
- Brocade M5424 FC8 I/O Module
- I/O Modules—Pass-Through
- Installing Enclosure Components
- Troubleshooting The Enclosure
- Technical Specifications
- Getting help
Dell PowerEdge M1000e Enclosure Owner's Manual
Removing A DC Power Supply
About this task
NOTE: For equipment
using –(48–60) V DC power supplies, a qualified electrician must perform
all connections to DC power and to safety grounds. Do not attempt
connecting to DC power or installing grounds yourself. All electrical
wiring must comply with applicable local or national codes and practices.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow all safety instructions that came
with the product.
CAUTION: The
system requires six power supplies for normal operation. On power-redundant
systems, remove and replace only one power supply at a time in a system
that is powered on.
NOTE: Modifying the modular enclosure redundancy policy is recommended to be performed while the modular enclosure is powered off.
NOTE: The power supply modules
have internal fans that provide thermal cooling to these modules.
A power supply module must be replaced if an internal fan failure
occurs.
NOTE: You may have to unlatch
and lift the optional cable management arm if it interferes with power
supply removal. For information about the cable management arm, see
the system’s rack documentation.
Steps
- Disconnect the power wires from the power source and the connector from the power supply you intend to remove.
- Disconnect the safety ground wire.
- Press the release latch on the power supply and slide the
power supply away from the chassis.
Figure 1. Removing and Installing a DC Power Supply 
- connector
- DC power supply
- release latch
- power supply handle
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\