1 | System identification button | | The identification buttons
on the front and back panels can be used to locate a particular system
within a rack. When
one of these buttons is pressed, the LCD panel on the front and the
system status indicator on the back flashes until one of the buttons
is pressed again. Press to toggle the system identification (ID) on
or off. If the system stops responding during POST,
press and hold the system ID button for more than five seconds to
enter BIOS progress mode. To reset iDRAC (if not
disabled in F2 iDRAC setup) press and hold the button for more than
15 seconds. |
2 | System identification connector | | Connects the optional system
status indicator assembly through the optional cable management arm. |
3 | iDRAC8 Enterprise port | | Dedicated management port. |
4 | Half-height PCIe expansion
card slot (3) | | Enables you to connect up to three half-height
PCI Express expansion cards. |
5 | Serial connector | | Enables you to connect a serial device
to the system. |
6 | Video connector | | Enables you to connect a VGA display
to the system. |
7 | USB port (2) | | Enables you to connect USB devices
to the system. The ports are USB 3.0-compliant. |
8 | Full-height PCIe expansion card slot (4) | | Enables you to connect up to four full-height PCI Express expansion
cards. |
| | |
9 | Ethernet connector (4) | | Four integrated
10/100/1000 Mbps Network Interface Card (NIC) connectors or Four integrated connectors that include:- Two 10/100/1000 Mbps NIC connectors
- Two 100 Mbps/1 Gbps/10 Gbps SFP+/10 GbE
T connectors
|
10 | Power supply unit (PSU1) | | - AC
- 495 W,
750 W, or 1100 W
- or
- DC
- 750 W or 1100 W
|
11 | Power supply unit (PSU2) | |