Dell PowerEdge R730 Owner's Manual

Installing the control panel

Prerequisites

Follow the safety guidelines listed in safety instructions section.
Follow the procedure listed in the Before working inside your system section.
Keep the #2 Phillips screwdriver ready.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
NOTE: Information tag lists system information such as Service Tag, NIC, and MAC address.
To install the information tag, push the information tag into the control panel slot.
Connect all the applicable cables to the control panel.
Slide the control panel into the slot in the chassis and secure the module with the screw.
Figure 1. Installing the control panel—3.5 inch hard drive system
1. control panel
2. control panel board
3. control panel connector cable
4. USB connector cable
5. screw
6. vFlash media connector cable
Figure 2. Installing the control panel—2.5 inch hard drive system
1. control panel
2. control panel board
3. control panel connector cable
4. USB connector cable
5. screw (2)
6. vFlash media connector cable
Figure 3. Installing the information tag
1. information tag
2. tab
3. slot

Next steps

Follow the procedure listed in the After working inside your system section.

欢迎

欢迎访问戴尔

Dell PowerEdge R730 Owner's Manual

Installing the control panel

Prerequisites

Steps

Next steps

对此内容评级