OEMR R250

Denne artikel præsenterer muligheder for at forstå og fejlfinde nogle almindelige årsager til blæserstøj på en PowerEdge-server. Det er også relevant for 100% blæserhastigheder.

I denne artikel beskrives, hvordan du får vist og rydder systemhændelsesloggen (SEL) i Systemopsætning.

Dell Technologies fraråder nedgradering af harddisk eller SSD-firmware, undtagen i validerede scenarier, på grund af uforudsigelige resultater og problemer med versionsrapportering.

The "Predictive failure reported for disk x" error continues to be logged every 24 hours, even after the identified drive has been replaced. The issue only affects drives connected to PERC Controllers in RAID configuration.

PowerEdge-servere går ned med fatale PCIe-fejl under opdatering af firmwaren til Kioxia CM6 NVMe-drev.

CPU er kan opfattes som varme, mens serveren er inaktiv.

During continuous reboot testing, the system may stop responding during the shutdown phase due to an internal error (CPU0000) on PowerEdge T150, R250, R350, T350 systems.

The Dell SS540 SAS solid state drive is reported as not correctly functioning.

This article describes how to find the iDRAC's current MAC address.

Når strømtælleren ruller over til brug, ruller strømtælleren over før rollover-tælleren. Dette fører til en fejlagtig strømspids, som kan begrænse serveren.

Dell solid state drive (SSD) fails after system reports low environment operating temperature.

Dell Samsung Serial Attached SCSI (SAS) PM1653 and PM1655 solid state drives may report excessive Sense Key faults 0x3, 0x11, 0x0, or 0x4, 0x29, 0x4. These faults have the potential to cause unexpected drive issues.

Dell Enterprise SAS, SATA SSD: SMART predictive failures triggered by remaining write endurance falling below the threshold

In some migration scenarios, the OpenManage Enterprise 4.0 target import operation may fail with an error 'Failed to decrypt backup archive' during migration. Use the following article to help in troubleshooting this scenario and various ways to address the failure.

Network port enumeration on Windows Server 2022 with Dell network adapters may swap port designations.

After an update to 7.00.00.00 or higher, the iDRAC9 web server may become inaccessible where the user has uploaded a custom or CA signed web certificate.

IDRAC kan ikke oprette forbindelse til en SMB-deling (Server Message Block), når den valgfrie "SMB3-delingskryptering" er aktiveret.

iDRAC rapporterer muligvis en CPU-temperaturadvarsel på grund af termisk spidsbelastning eller højere temperatur, når der køres en bestemt arbejdsbelastning.

BIOS/CPLD or backplane firmware DUP may fail to update when attempted soon after iDRAC restart.

This article describes what can happen while collecting SupportAssist logs using iDRAC9 UI. The operation may result in an error, or incomplete logs may be collected.

This article documents the known symptoms that can occur when the iDRAC9 fails to receive accurate Platform ID information from the CPLD controller during iDRAC boot. This issue can be encountered after the iDRAC is rebooted independently from the host server.

BIOS, CPLD, Backplane, PSU eller en anden firmwareopdatering på Red Hat Enterprise Linux (RHEL) 9 kan rapportere fejl, når der gøres forsøg på opdatering ved brug af Dell Update Package (DUP).

This article addresses an issue in which conversion of Windows Server from an evaluation to a fully licensed edition fails. The error that is returned appears to indicate a problem with the supplied product key, but the key is known to be valid.

Firmwaren til PowerEdge-serverharddiske er en kritisk komponent i serversystemet. Regelmæssig opdatering og vedligeholdelse af denne firmware er afgørende for serverens ydeevne, sikkerhed og kompatibilitet. Firmwareopdateringer til harddiske kan ofte rette kendte hardwarefejl og -problemer, adressere identificerede sårbarheder og sikkerhedsproblemer og potentielt introducere nye funktioner, forbedringer og forbedringer.

PowerEdge RAID-controller (PERC11, PERC10), HII-konfigurationshjælpeprogrammet (Human Interface Infrastructure) og iDRAC understøtter ikke systemudvidelse.

This how-to explains the commands and shows the results of outputs for the same to retrieve your service tag using a command console. It is displayed as the system serial number.

The VM does not turn on after configuring PCI Device passthrough on the ESXi host and adding the device to the VM. It gets stuck at 80% and then results in an error "total number of pages needed (4206594) exceeds the limit (917504)."

This article provides information about an EasyRestore Identity Module (IDM) failure and being unable to install the IDM manually.

Artiklen er en løsning til at løse problemet med systemet, der beder om eh-produktnøgle efter at have foretaget en hardwareændring.

This article explains how to generate a troubleshooting log for PowerVault TL2000/TL4000 using the graphical interface for recent firmware or Telnet for older versions.