Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Cooling Shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Riser 02 Exp card & Riser 2 & 3 blank
Riser 2
Identify the expansion card riser 2 highlighted in blue
Press the release tab and lift the riser from the system board
Riser 2c
Identify the Riser 2c highlighted in blue.
Pull the expansion card latch out of the slot and pull the expansion card from the system
Lift the riser to disengage from the system board and remove.
Internal Dual SD Module (IDSDM)
Identify the internal dual SD module (IDSDM) highlighted in blue
Pull up on the blue pull tab and lift the IDSDM out of the system
Internal SD Card
Position the part as shown in video.
Identify the internal SD card highlighted in blue
Locate the SD card slot on the internal dual SD module (IDSDM)
Press the card down to release it from the slot
Install
Internal SD Card
Position the part as shown in video.
Identify the internal SD card location highlighted in blue
Orient the SD card appropriately and insert into the slot.
Press the card into the card slot to lock it into place.
Internal Dual SD Module (IDSDM)
Identify the internal dual SD module (IDSDM) location highlighted in blue
Align the IDSDM connector with the connector on the system board
Press the IDSDM into the connector
Riser 2c
Identify the Riser 2c location highlighted in blue.
Align the riser to the slot and press down to connect to the system board.
Insert the card edge connector firmly into the expansion card connector and close the latch.
Riser 2
Identify the expansion card riser 2 location highlighted in blue
Align the screw and tab on the riser with the screw hole and slot on the system
Lower the riser into the system until the riser connector engages with the connector on the system board
Riser 02 Exp card & Riser 2 & 3 blank
Cooling Shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.