Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

PDF

Installing a hard drive or SSD

Prerequisites

CAUTION: When a replacement hot-swappable hard drive or SSD is installed and the server module is turned on, the hard drive or SSD automatically begins to rebuild. Make absolutely sure that the replacement hard drive or SSD is blank or contains data that you wish to have over-written. Any data on the replacement hard drive or SSD is immediately lost after the hard drive or SSD is installed.
NOTE: You must remove a hard drive or SSD to upgrade a hard drive or SSD or replace a faulty hard drive or SSD.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Remove the hard drive or SSD or hard drive or SSD blank.

NOTE: All operating systems do not support hot-swappable drive installation. See the documentation supplied with your operating system.

Steps

  1. Press the release button to open the hard drive or SSD carrier handle.
  2. Slide the hard drive or SSD carrier into the drive bay. Carefully align the channel on the hard drive or SSD carrier with the appropriate drive slot on the server module.
  3. Push the drive carrier into the slot until the handle makes contact with the server module.
  4. Rotate the carrier handle to the closed position while pushing the carrier into the slot until it locks into place.
    The status LED indicator displays a steady green light if the drive is installed correctly. The drive carrier LED green indicator flashes as the drive rebuilds.
    Figure 1. Installing a hard drive
    This image shows installing a hard drive
    1. release button
    2. hard drive(on backplane)
    3. hard drive
    4. hard drive carrier handle
    Figure 2. Installing an SSD
    This figure shows installing an SSD
    1. release button
    2. SSD
    3. SSD carrier handle

Next steps

Follow the procedure listed in the After working inside your system section.

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\