Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

PDF

Removing the hard drive or SSD backplane

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: To prevent damage to the hard drives or SSDs and the hard drive or SSD backplane, you must remove the hard drives or SSDs from the server module before removing the hard drive or SSD backplane.
CAUTION: Note the number of each hard drive or SSD and temporarily label them before removal so that you can replace them in the same locations.

  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  3. Follow the procedure listed in the Before working inside your system section.

  4. Remove the hard drive(s) or SSD(s).

Steps

  1. Pressing the release latches, hold both the edges of the backplane near the server module chassis and lift it up and away from the system.
  2. Remove the hard drive or SSD cage.
  3. Loosen the two retention screws securing the hard drive or SSD backplane cable connector to the system board connector.
  4. Lift the hard drive or SSD backplane up and away from the system.
    Figure 1. Removing the 2.5-inch (x2) hard drive or SSD backplane
    This figure shows removing a hard drive or SSD backplane.
    Figure 2. Removing the 1.8-inch (x4) SSD backplane
    This figure shows removing a PCIe SSD/SSD backplane.
    1. hard drive or SSD backplane
    2. hard drive or SSD backplane cable
    3. release latch (2)
    4. guide pin (3)
    5. retention screw on the backplane cable connector (2)
    6. connector on system board

Next steps

  1. Install the hard drive or SSD backplane.

  2. Install the hard drive or SSD.

  3. Follow the procedure listed in the After working inside your system section.

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\