Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

Setting up your system

Complete the following steps to set up your system:

1. Unpack the server module.
2. Remove the I/O connector cover from the server module connectors.
   CAUTION: While installing the server module, ensure that it is properly aligned with the slot on the enclosure to prevent damage to the server module connectors.
3. Install the server module in the enclosure.
4. Turn on the enclosure.
   NOTE: Wait for the chassis to initialize before you press the power button.
5. Turn on the server module by pressing the power button on the server module.
   Alternatively, you can also turn on the server module by using:

   • The server module iDRAC. For more information, see the Log in to iDRAC section.

   • The enclosure Chassis Management Controller (CMC), after the server module iDRAC is configured on the CMC. For more information, see the CMC User’s Guide at Dell.com/idracmanuals.