Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

PDF

Installing the PCIe extender or storage controller card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: PCIe extender or storage controller card is supported on systems with the SAS backplanes.
NOTE: You must remove the PCIe extender or storage controller card to replace a faulty PCIe extender or storage controller card or service other components inside the system.

  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  3. Remove the PCIe extender or storage controller card.

Steps

  1. Align the slots on the PCIe extender or storage controller card edge with the tabs on the support bracket.
    CAUTION: To prevent damage to the PCIe extender or storage controller card, you must hold the card only by its edges.
  2. Lower the PCIe extender or storage controller card on to the connector on the system board.
  3. Tighten the two retention screws on the hard drive or SSD backplane cable connector to secure the card on to the system board.
    Figure 1. Installing the PCIe extender or storage controller card
    This figure shows installing the PCIe extender or storage controller card.
    1. retention screw (2)
    2. slot on the PCIe extender or storage controller card
    3. tab on the PCIe extender or storage controller card support bracket
    4. standoff (2)

Next steps

  1. Install the following:

    1. Hard drives or SSDs

    2. Hard drive or SSD backplane

    3. Hard drive or SSD cage

  2. Follow the procedure listed in the After working inside your system section..

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\