Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

Troubleshooting hard drives

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

CAUTION: This troubleshooting procedure can destroy data stored on the hard drive. Before you proceed, back up all the files on the hard drive, if possible.

Steps

Run the appropriate controllers test and the hard drive tests in system diagnostics.
If the tests fail, go to step 3.
Take the hard drive offline and wait until the hard drive indicator codes on the drive carrier signal that the drive may be removed safely, then remove and reseat the drive carrier in the server module.
Restart the server module, enter the System Setup and confirm that the drive controller is enabled.
Ensure that any required device drivers are installed and are configured correctly.
NOTE: Installing a hard drive into another bay may break the mirror if the mirror state is optimal.
Remove the hard drive and install it in the other drive bay.
If the problem is resolved, reinstall the hard drive in the original bay.
If the hard drive functions properly in the original bay, the drive carrier could have intermittent problems. Replace the drive carrier.
If the hard drive is the boot drive, ensure that the drive is configured and connected properly.
Partition and logically format the hard drive.
If possible, restore the files to the drive.
If the problem persists, see the Getting help section.

Velkommen

Velkommen hos Dell

Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

Troubleshooting hard drives

Prerequisites

Steps

Bedøm indholdet