Dell EMC PowerVault MD 34XX/38XX Series Storage Arrays Administrator's Guide

Configuring SNMP alerts

1. Open the Configure Alerts dialog by performing one of these actions in the EMW:
   • On the Devices tab, select a node and then on the menu bar, select Edit > Configure Alerts. Go to step 3.
     NOTE: This option enables you to set up alerts for all the storage arrays connected to the host.
   • On the Setup, select Configure Alerts. Go to step 2.
2. Select one of the following options to specify an alert level:
   • All storage arrays — Select this option to send an alert notification about events on all storage arrays.
   • An individual storage array — Select this option to send an alert notification about events that occur in only a specified storage array.
   These results occur, depending on your selection:

   • If you selected All storage arrays, the Configure Alerts dialog is displayed.
   • If you selected An individual storage array, the Select Storage Array dialog is displayed. Select the storage array for which you want to receive alert notifications and click OK. The Configure Alerts dialog is displayed.

   NOTE: If you do not know location of the selected storage array, click Blink to turn on the LEDs of the storage array.
3. To configure an SNMP alert originating from the event monitor, see Creating SNMP Alert Notifications Originating from the Event Monitor.
4. To configure an SNMP alert originating from the storage array, see Creating SNMP Alert Notifications Originating from the Storage Array.