Dell PowerVault MD 32XX/36XX Series Storage Arrays CLI Guide

Set Host

Description

This command assigns a host to a host group or moves a host to a different host group. You can also create a new host group and assign the host to the new host group with this command. The actions performed by this command depend on whether the host has individual mappings or does not have individual mappings.

Syntax

set host [
                                 hostName] 
                                 hostGroup=("
                                 hostGroupName" | none | defaultGroup)
                                 userLabel="
                                 newHostName"
                                 hostType=(
                                 hostTypeIndexLabel | 
                                 hostTypeIndexNumber)

Parameters

Parameter	Description
`host`	The name of the host that you want to assign to a host group. Enclose the host name in square brackets ([ ]). If the host name has special characters, you must also enclose the host name in double quotation marks (" ").
`hostGroup`	The host group to which you want to assign the host. (The following table defines how the command runs if the host does or does not have individual virtual disk-to-LUN mappings.) Enclose the host group name in double quotation marks (" "). The defaultGroup is the host group that contains the host to which the virtual disk is mapped.
`userLabel`	The new host name. Enclose the host name in double quotation marks (" ").
`hostType`	The index label or number of the host type for the HBA host port. Use the `show storageArray hostTypeTable` command to generate a list of available host type identifiers. If the host type has special characters, enclose it in double quotation marks (" ").

Host Group Parameter	Host Has Individual Virtual Disk-to-LUN Mappings	Host Does Not Have Individual Virtual Disk-to-LUN Mappings
hostGroupName	The host is removed from the present host group and is placed under the new host group defined by hostGroupName.	The host is removed from the present host group and is placed under the new host group defined by hostGroupName.
none	The host is removed from the host group as an independent partition and is placed under the root node.	The host is removed from the present host group and is placed under the default group.
defaultGroup	The command fails.	The host is removed from the present host group and is placed under the default group.

NOTE: When you use this command, you can specify one or more of the optional parameters. You do not, however, need to use all of the parameters.

NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.

Bienvenido

Bienvenido a Dell

Dell PowerVault MD 32XX/36XX Series Storage Arrays CLI Guide

Set Host

Description

Syntax

Parameters

Califique este contenido