PowerStore:無法對應儲存網路 -不適用於對應。

Summary: 從 PowerStoreOS 2.0 開始,可在初始部署 PowerStore 後新增額外的 I/O 模組。必須執行服務指令檔,才能將新的 I/O 模組認可至組態,才能使用。

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.

Symptoms

當嘗試將儲存網路指派給新的 I/O 模組時,MAP STORAGE NETWORK按鈕會顯示為灰色:一或多個選取的埠不適用於對應。

複寫標籤為灰色:一或多個選取的埠不適用於標記。

用於複製的標籤

不適用的訊息
 
 

Cause

如果在初始部署後將 I/O 模組新增至 PowerStore,可將儲存網路指派給埠,且可使用 I/O 模組。

若要標記用於複製的埠,至少必須將一個儲存網路對應至乙太網路埠。

Resolution

您可以使用服務指令檔檢查認可狀態,svc_commit_slic狀態

插槽 0 的Examples:svc_commit_slic狀態 0

尚未認可的 I/O 模組:
[SVC:service@16XXXXX-A user]$ svc_commit_slic status 0

------------------------------ Slot 0, NodeA --------------------------
----
SLIC:BaseEnclosure-NodeA-IoModule0,use:ready_for_activation, state:Healthy, comp_state:ok, power:on, model:32 Gb Fibre v1
““““
““““
Engine state machine: IOM_ACTIVATION_STATE_NOT_STARTED
Platform activation state: READY_FOR_ACTIVATION

已承諾的 I/O 模組:
[SVC:service@16XXXXX-A user]$ svc_commit_slic status 0


------------------------------ Slot 0, NodeA ------------------------------
SLIC:BaseEnclosure-NodeA-IoModule0, use:in_use, state:Healthy, comp_state:ok, power:on, model:32 Gb Fibre v1
““““
““““
Engine state machine: IOM_ACTIVATION_STATE_NOT_STARTED
Platform activation state: ACTIVATED


如需如何使用此腳本的進一步指導,請參閱svc_commit_slic -h


如果您在此過程中遇到任何問題,請聯絡 Dell EMC 技術支援部門或您的授權服務代表,並引用此知識庫文章 ID。

Affected Products

PowerStore 1000X, PowerStore 1000T, PowerStore 3000X, PowerStore 3000T, PowerStore 5000X, PowerStore 5000T, PowerStore 500T, PowerStore 7000X, PowerStore 7000T, PowerStore 9000T

Products

PowerStore 9000X
Article Properties
Article Number: 000199111
Article Type: Solution
Last Modified: 28 Jun 2023
Version:  3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.