- Notes, cautions, and warnings
- Additional resources
- Platform Overview
- Technical specifications
- Hardware component descriptions
- Disk-array enclosures
- Cabling
- Rail kits and cables
On the rear of the storage processor, viewing from left to right, are:
The following illustration shows the location of the SP components:
Location | Description | Location | Description |
---|---|---|---|
Management LAN (RJ45) port | SP unsafe to remove LED (black with white hand) | ||
Grounding screw (required for DC-powered systems) | SP fault LED | ||
Torque knob for SP removal | SP power LED | ||
Two converged network adapter (CNA) ports (labeled 4 and 5) | Non-maskable interrupt (NMI) push button (password reset button) 1 | ||
Two 12 Gb/s mini-SAS HD ports (labeled 0 and 1) | SP memory or boot fault LED | ||
Two 10 GbE ports (labeled 2 and 3)
NOTE:Unity XT 380/380F systems that are manufactured in the second half of 2022 and later, will not include these two 10 GbE ports. For more information, see the
Dell Unity XT: Introduction to the Platform - A Detailed Review white paper on Online Support.
| Mini-HDMI port (not used) | ||
USB 3.0 port | Service LAN (RJ45) port |
The following table describes the SP status LEDs.
LED | Location | Color | State | Description |
---|---|---|---|---|
SP power LED | Green | On | The SP is on main power. | |
Blinking (1 Hz) | The SP is initializing a serial over LAN (SOL) session (standby mode). | |||
— | Off | The SP is off. | ||
Unsafe to Remove LED | White | On | DO NOT remove the SP.
NOTE:Improper removal of the SP when this LED is lit could cause data loss during critical situations.
| |
— | Off | Safe to remove the SP without the risk of data loss when the SP has been properly prepared. | ||
SP fault LED | Amber | Blinking once every four seconds (.25 Hz) | BIOS is running. | |
Blinking once every second (1 Hz) | POST is running. | |||
Blinking four times every second (4 Hz) | POST has completed, and operating system boot has started. | |||
On | An SP fault is detected. | |||
Blue | Blinking once every four seconds (.25 Hz) | Operating system is booting. | ||
Blinking once every second (1 Hz) | Operating system driver is starting. | |||
Blinking four times every second (4 Hz) | Operating system caching driver is starting. | |||
On |
| |||
— | Off | All operating system software has booted, and the SP is ready for I/O. | ||
Amber and blue | Alternating at one second intervals | SP is in Service mode. | ||
Amber and then immediately blue every three seconds | System is not initialized, and no management IP address assigned. | |||
SP memory or boot fault LED | Amber | On | The SP cannot boot due to a memory or boot fault. | |
— | Off | Normal Operation. |