- Notes, cautions, and warnings
- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Major components of your system
- Removing and installing components
- Recommended tools
- Screw list
- Disassembly and reassembly
- Base cover
- Battery
- Coin-cell battery
- Solid-state drive
- Heat sink
- Fan
- Speakers
- WLAN card
- WWAN card
- Touchpad
- Power-adapter port
- Display assembly
- I/O board
- Power-button board
- Power button with fingerprint reader
- System board
- Display bezel
- Display panel
- Display hinges
- Camera
- Display back-cover
- Display cable
- Palm-rest and keyboard assembly
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help
Dell Latitude 3301 Service Manual
Installing the display cable
NOTE This procedure is not applicable to computers shipped with a WWAN configuration.
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of display cable and provides a visual representation of the installation procedure.
- Adhere the tape securing the display cable to the back-cover.
- Adhere the display cable to the display back-cover.
- Install the display bezel.
- Install the display panel.
- Install the display assembly.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\