Installing the touchpad
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of touchpad and provides a visual representation of the installation procedure.
- Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
- Replace the two (M1.6x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
- Align and place
the touchpad bracket into the slot on the palm-rest and keyboard assembly.
- Replace the three (M1.6x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
- Slide the touchpad cable into its connector on
the system board and close the latch to secure the cable.
- Adhere the tape that secures the touchpad to the palm-rest and keyboard assembly.
Data is not available for the Topic