Installing the I/O board
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of I/O board and provides a visual representation of the installation procedure.
- Align and place the I/O board
on the palm-rest and keyboard assembly.
- Replace the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
- Replace the screw (M2.5x2.5) that secures the I/O board to the palm-rest
and keyboard assembly.
- Connect the I/O-board cable to the I/O board and close the latch to secure the cable.
- Adhere the tape that secures the I/O board to the I/O board.
- Adhere the Mylar that secures the I/O board to the palm-rest and keyboard assembly.
- Using the alignment posts, close the display hinges.
- Replace the two screws (M2.5x3.5) that secure the left display hinge to the I/O board and palm-rest and keyboard assembly.
- Replace the screw (M2x4) that secure the left display hinge to the palm-rest and keyboard assembly.
Data is not available for the Topic